Stainless steel water pipe: What problems should be paid attention to when using stainless steel pipe fittings?

Stainless steel water pipes Stainless steel pipes are widely used in our domestic water pipes and play an important role.


What problems should be paid attention to when using stainless steel clamping pipe fittings in Sanqing?

1. If there is any relaxation, please relax the caliper and press it again in the original clamping pressure (pay attention to the direction of the regular hexagon). Thin-walled stainless steel pipe


2. When the pipe is bent, please correct it in the straight pipe position. Can not take the correction of pipe fittings, responsible for the card stage, which is also the cause of leakage factors, please note. Clamping type pipe fittings

3. The pipeline system is suitable for other media (such as petroleum, chemical, natural gas, gas, etc.), please discuss with the producer, the rubber seal may be corroded by the media, and it will bring leakage.


4. Corrosion measures near the coast or more salt water should be considered. In addition, also pay attention to well water, sea water, hot spring fluid.

5. When applying hot water, if the water source is not well treated, please consider whether it will affect the pipeline.

6. Place the pipe fittings to avoid direct sunlight as much as possible. Please use plastic tape or safety cloth.

7. Wipe clean when the stainless steel clamping pipe fittings are bonded to oil stains. The position of the tube and the tubular rubber sealing ring is free of impurities. If there are impurities, it should be cleaned immediately to avoid more serious effects.

8, stainless steel clamp type pipe fittings, thin-walled stainless steel pipe joints, please use matching tools to operate correctly to avoid defects and dents, especially on site, pay attention to textured parts.

9. If the pipe cannot be successfully embedded in the pipe, it is necessary to see the burrs on the pipe interface, especially the burrs. The burrs and burrs will affect the tight connection between the pipe fittings and the pipe.

10. First turn the thread to tighten to avoid falling off due to rotating wires.

and above are the contents collected by Cangzhou Sanqing Industry and Trade Co., Ltd. If necessary, please contact us.